Paragon PMT18 Knife Making Kiln

Paragon PMT-18 Heat Treating Furnace Save Time Machine shops save time with a furnace at their disposal in their own shop. You will no longer send a die out for heat treating, wait for its return, and then send it out again for additional heat treating. Do the work yourself and start a new profit center in your shop. Solid Construction The door swings open with one-handed operation. The PMT-18 furnace is insulated with refractory firebrick. The elements are mounted in dropped, recessed grooves machined into the firebrick. Paragon invented this type of groove in 1952. This groove protects the element for long life and low maintenance. Elements are simple to replace because they’re exposed rather than embedded. You can thread new elements into place following instructions in the manual. The firing chamber is protected by a steel case painted in high temperature blue. A built-in stand lifts the firing chamber safely off your worktable, so no extra stand is needed. The door is mounted with a heavy-duty hinge for smooth opening. A micro-switch shuts off the power to the elements when the door is opened. We use high temperature wire in the switch box for long life. A heat shield, mounted between the switch box and furnace, helps keep the switch box components cool even during extended operation. To further dissipate heat, the switch box is extra large and generously louvered. Each furnace comes with a cord and plug for immediate installation and a one year warranty. Complete Instructions Your furnace includes a wiring diagram, programming instructions, and heat treating manual. The manual gives basic heat treating instructions for D2, 440C, ATS 34 and 154 CM. The manual is written in plain English for the beginner. Optional Gas Injection Flow Meter During heat treating, scale forms on the surface of the steel. One way to eliminate most scaling is to wrap the steel in stainless steel foil. An easier way is to install the gas injection flow meter on your furnace. It is available as either an add-on kit, or you can order the furnace with the meter installed. The meter regulates the flow of an inert gas, such as argon, inside the furnace. The gas displaces the oxygen to prevent most scaling. Please remember that results with the flow meter vary depending on the type of inert gas you use and your level of experience. Max Temperature: 2350F (1287C) Amps: 27 Phase: 1 Watts: 6500 Nema details: 6-50R Breaker Size: 50 Circuit Copper Wire Size: 6 TUV Tested to CSA and UL Standard 499: No CE: No IMPORTANT: Some areas such as Canada and Europe require a lid or door safety switch on kilns. Control Type: Sentry Digital 12-Key Non-Ceramic Voltage: 240 Hertz: 60 Kiln Type: Front Loading Square Sides: 4 Inner Dimensions Chamber Volume: 1.80 Cubic Ft. (50.97 Litres) Chamber Width: 13.00” (330mm) Chamber Depth: 18.00” (457mm) Chamber Height: 13.00” (330mm) Outer Dimensions Outer Size: 36.00”W x 38.00”D x 38.00”H Ship Weight: 309.00 Lbs (140.16 Kg.)